Tile Installation & Repair in Inglewood, CA

I.OVERVIEW

Paragon Home Services has served Inglewood homeowners since 2007 — 18+ years of tile installation & repair experience specific to the South Bay's unique construction era, climate, and infrastructure. Every project is managed by licensed, W-2 technicians with the tools and expertise your home deserves.

II.LOCAL CONDITIONS

Why Inglewood Homes Need Expert Tile Installation

III.PROCESS

Our Tile Installation Process

1. 1

   Substrate evaluation — we check existing substrate flatness, structural integrity, and moisture management.

2. 2

   Substrate prep — cement board or foam panels installed where needed; existing substrate prepped and primed as required.

3. 3

   Waterproofing — Schluter Kerdi or RedGard membrane on showers and wet areas; documented at every penetration and corner.

4. 4

   Layout and dry-fit — tile dry-laid to confirm pattern, focal points, and cut locations before any setting begins.

5. 5

   Setting — large-format-rated mortar with full back-buttering; leveling clips on tiles over 15 inches.

6. 6

   Grouting — appropriate grout (cementitious, epoxy, or urethane) selected for the application; joints uniformly filled and tooled.

7. 7

   Sealing — natural stone and porous tiles sealed; grout sealer applied where appropriate.

8. 8

   Final walkthrough and care instructions.

IV.CAPABILITIES

Tile Capabilities

• Bathroom shower tile (full Schluter Kerdi waterproofing)
• Bathroom floor tile
• Kitchen backsplash (subway, mosaic, slab, large-format)
• Living area floor tile and large-format porcelain
• Natural stone (travertine, marble, slate, limestone)
• Outdoor tile (patio, pool deck) with proper substrate
• Fireplace surrounds and accent walls
• Heated floor system installation under tile
• Tile repair and re-grouting
• Steam shower waterproofing
• Curbless shower construction

V.PARAGON IN INGLEWOOD

Serving All of Inglewood

VI.FAQ

Tile — Frequently Asked Questions

Why do shower tiles leak after a few years?

Almost always because the waterproofing wasn't done correctly — drywall behind tile, missing or inadequate membrane at the curb and corners, or a failed mud-set pan. The tile and grout are not the waterproofing; the substrate is. Failed shower waterproofing leads to wet wall framing, mold, and eventually a full tear-out. We use Schluter Kerdi sheet membrane on every shower for this reason.

Can you install tile over my existing tile?

Sometimes — if the existing tile is well-bonded, the substrate is structurally sound, and the height buildup doesn't create transition or appliance issues. Often the cleaner approach is to demo the existing tile so we can verify substrate condition and waterproofing. We assess case-by-case.

How long does a bathroom tile job take?

A typical full bathroom shower and floor tile installation takes 4–7 working days from demo to final grout cure: 1 day demo, 1 day substrate and waterproofing, 2–3 days setting, 1 day grout, 1 day seal. Larger or natural-stone installations extend the timeline.

Do natural stone and porcelain need different installation?

Yes. Natural stone is more sensitive to mortar choice (white-set thinset to avoid staining), requires sealing before and after grouting, and benefits from larger trowel sizes for full coverage. Porcelain large-format requires medium-bed mortar and leveling clips. We adjust the install for the material — most failures happen when one approach is used on every job.

VII.CONTINUE

View the full Tile Installation & Repair service page for detailed scope, process, and pricing: